Home › Engine / Hybrid System › K3-VE ENGINE CONTROL › SFI SYSTEM › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002967 K3-VE ENGINE CONTROL _0014971 SFI SYSTEM U

K3-VE ENGINE CONTROL  SFI SYSTEM  FAIL-SAFE CHART  


If any of the following DTCs are set, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.

DTCs Components Fail-Safe Operations Fail Safe Deactivation Conditions
P0010 Camshaft Timing Oil Control Valve Oil control valve energizing control prohibited. Pass condition detected
P0105 Manifold Absolute Pressure Sensor ECM uses value estimated from throttle opening angle, engine speed and ISC valve opening angle.
Intake manifold pressure value fixed if throttle position sensor circuit malfunctioning.
Fuel-cut executed if throttle opening angle and engine speed exceed certain value.
Pass condition detected
P0110 Intake Air Temperature Sensor Constant value stored in ECM memory used. Pass condition detected
P0115 Engine Coolant Temperature Sensor Constant value stored in ECM memory used.
(Radiator fan switched ON)
Pass condition detected
P0120 Throttle Position Sensor Constant value stored in ECM memory used. Pass condition detected
P0325 Knock Sensor Ignition timing retarded. Pass condition detected
P0340 Camshaft Position Sensor Constant value stored in ECM memory used.
(VVT angle retarded)
Pass condition detected
P0505 Idle Speed Control System ECM stops controlling ISC valve.
Ignition timing retarded and fuel-cut executed depending on throttle opening angle and ISC valve position.
-
P0535 A/C Evaporator Temperature Sensor Constant value stored in ECM memory used.
(Air conditioner switched OFF)
Pass condition detected