Home › Engine / Hybrid System › K3-VE ENGINE CONTROL › SFI SYSTEM › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002967 K3-VE ENGINE CONTROL _0014971 SFI SYSTEM C

K3-VE ENGINE CONTROL  SFI SYSTEM  P1603  Engine Stall History  


DESCRIPTION

When the engine stalls after starting, DTC is output. To grasp the situation when DTC is output, the freeze-frame data can be checked by using the intelligent tester. Because the engine running conditions when it stalls can be checked by using the freeze-frame data, vehicle maintenance services can improve. Moreover, because an engine stall due to lack of fuel is also detected, the fuel must be checked before operation. (An engine stall may be detected due to cranking, even if the engine does not stall.)

DTC No. Detection Item DTC Detection Condition MIL Memory
P1603 Engine Stall History After monitoring for startability problems (P1604) finishes and 5 seconds or more elapse after starting the engine, with the engine running, the engine stops without the ignition switch being operated.
(1 trip detection logic)
- DTC stored

CAUTION / NOTICE / HINT

HINT:
·

When other DTCs are displayed, first troubleshoot the corresponding DTC.

·

Because DTC P1603 differs from the conventional DTC, the following procedure is described as an example.



PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P1603)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON and turn the tester on.


c.

Select the following menu items: Powertrain / Engine and ECT / DTC.

Powertrain > Engine > Trouble Codes
50001 206

d.

Read DTCs.

Result:
Result Proceed to
P1603 A
P1603 and other DTCs B




A

2.CHECK FREEZE FRAME DATA

B

2.CHECK FREEZE FRAME DATA
HINT:

Using the time series freeze-frame data, check the data when and after the DTC is detected, to be used for troubleshooting.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON and turn the tester on.


c.

Check the time series freeze-frame data following the instructions displayed on the intelligent tester, and check the vehicle conditions when the engine stalls.

Click hereEngine / Hybrid System>K3-VE ENGINE CONTROL>SFI SYSTEM>FREEZE FRAME DATA


d.

Check the freeze-frame data whether the engine was cool or warmed up.

Tester Display
Coolant Temp -


e.

Using the freeze-frame data, check whether the engine was idling, running at a constant speed, decelerating, accelerating, starting and stopping.

Tester Display
Engine Speed ISC STEP Position
Vehicle Speed ISC Duty
Throttle Sensor Position Shift Signal
Throttle Position Stop Light Signal


f.

Check the feedback performance state.

Tester Display
Short FT #1 O2S B1 S1
Long FT #1 -


g.

Check the freeze-frame data of the engine load/electric load.

Tester Display
Calculate Load A/C Signal
Electrical Load Signal Power Steering Signal


h.

Check the freeze-frame data of the fuel injection.

Tester Display
Injection Volume Injection Time


i.

Referring to the above freeze-frame data, perform the reproduction test.


j.

Based on the freeze-frame data and the reproduction test, specify the malfunctioning section while comparing to the reference values shown in the ECM data list description.

Click hereEngine / Hybrid System>K3-VE ENGINE CONTROL>SFI SYSTEM>DATA LIST / ACTIVE TEST

Result:
Result Proceed to
The malfunctioning section can be specified. A
The malfunctioning section can not be specified. B




A

CHECK AND REPAIR LOCATION WHERE MALFUNCTION EXIST

B