Home › Engine / Hybrid System › K3-VE ENGINE CONTROL › SFI SYSTEM › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002967 K3-VE ENGINE CONTROL _0014971 SFI SYSTEM C

K3-VE ENGINE CONTROL  SFI SYSTEM  P1605  Rough Idling  


DESCRIPTION

DTC is output when the engine conditions change from a small load and a stable idle speed to a low idle speed. The freeze-frame data, which have memorized the engine conditions when DTC was output, can be checked using the intelligent tester. Because the engine conditions when the idle speed is unstable can be checked by the freeze-frame data, vehicle maintenance services can be improved. Moreover, because the idle speed instability due to a lack of fuel is also detected, the fuel level must be checked before operation.

DTC No. Detection Item DTC Detection Condition MIL Memory
P1605 Rough Idling Either of following condition met:
(1 trip detection logic)
·

The engine idle speed drops to 400 rpm or less.

·

A change in engine idle speed exceeding the specified level is detected more than 256 times in succession.


- DTC stored

CAUTION / NOTICE / HINT

HINT:
·

When other DTCs are displayed, first troubleshoot the corresponding DTC.

·

Because DTC P1605 differs from the conventional DTC, the following procedure is described as an example.



PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P1605)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON and turn the tester on.


c.

Enter the following menus: Powertrain / Engine / DTC.

Powertrain > Engine > Trouble Codes
50001 206

d.

Read DTCs.

Result:
Result Proceed to
P1605 A
P1605 and other DTCs B




A

2.CHECK FREEZE DATA

B

2.CHECK FREEZE DATA
HINT:

Using the time series freeze-frame data, check the data when and after the DTC is detected, to be used for troubleshooting.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON and turn the tester on.


c.

Check the time series freeze-frame data following the instructions displayed on the intelligent tester, and check the vehicle conditions when the idle speed was unstable.

Click hereEngine / Hybrid System>K3-VE ENGINE CONTROL>SFI SYSTEM>FREEZE FRAME DATA


d.

Check the freeze-frame data whether the engine was cool or warmed up.

Tester Display
Coolant Temp -


e.

Check the freeze-frame data of the engine idling.

Tester Display
Engine Speed -


f.

Check the feedback performance status.

Tester Display
Short FT #1 O2S B1 S1
Long FT #1 -


g.

Check the freeze-frame data of the fuel injection.

Tester Display
Injection Volume Injection Time


h.

Check the freeze-frame data of the engine load/electric load.

Tester Display
Calculate Load A/C Signal
Electrical Load Signal Power Steering Signal


i.

Referring to the above freeze-frame data, perform the reproduction test.


j.

Based on the freeze-frame data and the reproduction test, specify the malfunctioning section while comparing to the reference values shown in the ECM data monitor description.

Click hereEngine / Hybrid System>K3-VE ENGINE CONTROL>SFI SYSTEM>DATA LIST / ACTIVE TEST

Result:
Result Proceed to
The malfunctioning section can be specified. A
The malfunctioning section can not be specified. B




A

CHECK AND REPAIR ERROR PART

B