Home › Engine / Hybrid System › 3SZ-VE ENGINE CONTROL › THROTTLE BODY › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002968 3SZ-VE ENGINE CONTROL _0014974 THROTTLE BODY G

3SZ-VE ENGINE CONTROL  THROTTLE BODY  INSPECTION  


PROCEDURE

Hide 22210 1.INSPECT THROTTLE BODY ASSEMBLY

A126619C01
2.677,0.375 3.052,0.271 true 2.646,0.823 2.969,1.24 true 2.417,1.115 2.198,1.792 true 3.083,0.167 3.427,0.594 0.344,0.427 10 *1 2.104,1.844 2.479,2.177 0.375,0.333 10 *2 3.01,1.281 3.354,1.677 0.344,0.396 10 *a
*1 Throttle Stop Screw
*2 Throttle Lever
*a No clearance


a.

Check that the throttle valve shaft does not rattle.


b.

Check that none of the ports are clogged.


c.

Check that the throttle valve opens and closes smoothly.


d.

Check that there is no clearance between the throttle stop screw and throttle lever when the throttle valve is fully closed.

NOTICE:

Do not adjust the throttle stop screw.



Hide 89690 2.INSPECT IDLE SPEED CONTROL VALVE

A126620C01
1.375,0.104 1.781,0.594 0.406,0.49 10 *a
*a Component without harness connected
(Idle Speed Control Valve)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 1 27°C (81°F) 45.6 to 50.4 Ω
4 - 2 27°C (81°F) 45.6 to 50.4 Ω


If the result is not as specified, replace the idle speed control valve.


Hide 89452G 3.INSPECT THROTTLE POSITION SENSOR

A126615C01
1.813,0.542 1.729,0.76 true 2.021,0.542 2.104,0.76 true 2.281,0.427 2.51,0.427 true 1.417,0.073 1.833,0.479 0.417,0.406 10 *a 2.583,0.354 3.063,0.719 0.479,0.365 10 VC 2.094,0.823 2.323,1.115 0.229,0.292 10 - 1.521,0.813 2,1.167 0.479,0.354 10 PSW
*a Component without harness connected
(Throttle Position Sensor)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (VC) - 2 (-) 25°C (77°F) 2.5 to 5.0 Ω


If the result is not as specified, replace the throttle position sensor.


b.

Check the resistance change when the throttle lever is fully closed and opened.

Standard:

The resistance increases in proportion to the angle of the throttle lever.


Standard Resistance (HINT):
Tester Connection Condition Specified Condition
2 (-) - 3 (PSW) Fully closed 0.3 to 5.8 kΩ
2 (-) - 3 (PSW) Fully open 1.98 to 9.16 kΩ


If the resistance is not as specified, replace the throttle position sensor.