Home › Engine / Hybrid System › 3SZ-VE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002968 3SZ-VE ENGINE CONTROL _0014980 ENGINE COOLANT TEMPERATURE SENSOR G

3SZ-VE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT ENGINE COOLANT TEMPERATURE SENSOR

a.
A126612C01
0.635,1.719 1.156,2.125 0.521,0.406 10 30 0.635,1.906 1.052,2.281 0.417,0.375 10 20 0.635,2.188 1.094,2.635 0.458,0.448 10 10 0.729,2.5 1.115,2.938 0.385,0.438 10 5 0.729,3.198 1.063,3.563 0.333,0.365 10 1 0.583,3.521 0.979,3.885 0.396,0.365 10 0.5 0.583,3.948 1.01,4.26 0.427,0.313 10 0.2 0.917,4.021 1.365,4.417 0.448,0.396 10 -20 1.302,4.021 1.656,4.406 0.354,0.385 10 0 1.573,4.021 2,4.396 0.427,0.375 10 20 1.896,4.021 2.292,4.427 0.396,0.406 10 40 2.219,4.021 2.594,4.396 0.375,0.375 10 60 2.542,4.021 2.854,4.354 0.313,0.333 10 80 0.875,4.198 1.302,4.521 0.427,0.323 10 (-4) 1.167,4.198 1.615,4.563 0.448,0.365 10 (32) 1.479,4.198 1.875,4.542 0.396,0.344 10 (68) 1.781,4.198 2.26,4.552 0.479,0.354 10 (104) 2.188,4.198 2.667,4.594 0.479,0.396 10 (140) 2.594,4.198 3.083,4.563 0.49,0.365 10 (176) 1.927,2.021 2.458,2.479 0.531,0.458 10 *a 0.323,2.635 0.74,2.969 0.417,0.333 10 *b 1.635,4.448 2.052,4.667 0.417,0.219 10 *c
*a Component without harness connected
(Engine Coolant Temperature Sensor)
*b kΩ
*c °C (°F)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 2.29 to 2.60 kΩ
80°C (176°F) 0.302 to 0.327 kΩ


NOTICE:

In case of checking the engine coolant temperature sensor in water, do not allow water to contact the terminals. After checking, dry the engine coolant temperature sensor.


If the result is not as specified, replace the engine coolant temperature sensor.