Home › Engine / Hybrid System › 3SZ-VE ENGINE CONTROL › MANIFOLD ABSOLUTE PRESSURE SENSOR › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002968 3SZ-VE ENGINE CONTROL _0014982 MANIFOLD ABSOLUTE PRESSURE SENSOR G

3SZ-VE ENGINE CONTROL  MANIFOLD ABSOLUTE PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89421B 1.INSPECT MANIFOLD ABSOLUTE PRESSURE SENSOR

A239855C01
1.313,1.229 0.76,1.594 true 2.094,1.229 2.677,1.594 true 0.115,0.115 0.615,0.604 0.5,0.49 10 *a 0.625,1.625 1.146,2.052 0.521,0.427 10 - 2.698,1.656 3.146,2.01 0.448,0.354 10 VC
*a Front view of wire harness connector
(to Vacuum Sensor)


a.

Inspect the power source voltage.

i.

Disconnect the vacuum sensor connector.


ii.

Turn the ignition switch to ON.


iii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
3 (VC) - 1 (-) Ignition switch ON 4.5 to 5.5 V



iv.

Turn the ignition switch off.


v.

Reconnect the vacuum sensor connector.



b.

Check the vacuum and pressure.

i.

Connect the intelligent tester or Techstream to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the intelligent tester or Techstream on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / MAP.

Powertrain > Engine > Data List
Tester Display
MAP
50003 206 31

v.

Read the MAP value.

OK:
Condition Specified Condition
No pressure applied Same as atmospheric pressure
Vacuum applied Indicates vacuum
Pressure applied Indicates pressure


If the result is not as specified, replace the vacuum sensor.