Home › Engine / Hybrid System › 3SZ-VE ENGINE CONTROL › SFI SYSTEM(w/o Rear Heated Oxygen Sensor) › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002968 3SZ-VE ENGINE CONTROL _0014987 SFI SYSTEM(w/o Rear Heated Oxygen Sensor) D

3SZ-VE ENGINE CONTROL  SFI SYSTEM(w/o Rear Heated Oxygen Sensor)  DTC CHECK / CLEAR  


CHECK DTC


a.

Connect the tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 206

e.

Check the DTC(s) and freeze frame data, and then write them down.




CLEAR DTC (Using an intelligent tester)


a.

Connect the tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Clear DTCs
50002 206

e.

Erase the DTCs.



CLEAR DTC (Without using an intelligent tester)


a.

Perform either of the following operations.

i.

Disconnect the negative battery cable for more than 1 minute.


ii.

Remove the EFI fuse from the engine room relay block located inside the engine compartment for more than 1 minute.