CHECK DTC
Connect the intelligent tester or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester or Techstream on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Check the DTC(s) and freeze frame data, and then write them down.
Check the details of the DTC(s) (See page Engine / Hybrid System>3SZ-VE ENGINE CONTROL>SFI SYSTEM(w/ Rear Heated Oxygen Sensor)>DIAGNOSTIC TROUBLE CODE CHART).
CLEAR DTC (Using the intelligent tester or Techstream)
Connect the intelligent tester or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester or Techstream on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Erase the DTCs.
CLEAR DTC (Without using the intelligent tester or Techstream)
Perform either of the following operations.
Disconnect the negative battery cable for more than 1 minute.
Remove the EFI fuse from the engine room relay block located inside the engine compartment for more than 1 minute.