If any of the following DTCs are set, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.
| DTCs | Components | Fail-Safe Operations | Fail Safe Deactivation Conditions |
|---|---|---|---|
| P0010 | Camshaft Timing Oil Control Valve | Oil control valve energizing control prohibited. | Pass condition detected |
| P0105 | Manifold Absolute Pressure Sensor | ECM uses value estimated from throttle opening angle, engine speed and ISC valve opening angle.
Intake manifold pressure value fixed if throttle position sensor circuit malfunctioning. Fuel-cut executed if throttle opening angle and engine speed exceed certain value. |
Pass condition detected |
| P0110 | Intake Air Temperature Sensor | Constant value stored in ECM memory used. | Pass condition detected |
| P0115 | Engine Coolant Temperature Sensor | Constant value stored in ECM memory used.
(Radiator fan switched ON) |
Pass condition detected |
| P0120 | Throttle Position Sensor | Constant value stored in ECM memory used. | Pass condition detected |
| P0325 | Knock Sensor | Ignition timing retarded. | Pass condition detected |
| P0340 | Camshaft Position Sensor | Constant value stored in ECM memory used.
(VVT angle retarded) |
Pass condition detected |
| P0505 | Idle Speed Control System | ECM stops controlling ISC valve.
Ignition timing retarded and fuel-cut executed depending on throttle opening angle and ISC valve position. |
- |
| P0535 | A/C Evaporator Temperature Sensor | Constant value stored in ECM memory used.
(Air conditioner switched OFF) |
Pass condition detected |