Home › Engine / Hybrid System › 3SZ-VE ENGINE CONTROL › SFI SYSTEM(w/ Rear Heated Oxygen Sensor) › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002968 3SZ-VE ENGINE CONTROL _0014988 SFI SYSTEM(w/ Rear Heated Oxygen Sensor) C

3SZ-VE ENGINE CONTROL  SFI SYSTEM(w/ Rear Heated Oxygen Sensor)  P0116  Engine Coolant Temperature Circuit Range/Performance Problem  


DESCRIPTION

Refer to DTC P0115 (See page Engine / Hybrid System>3SZ-VE ENGINE CONTROL>SFI SYSTEM(w/ Rear Heated Oxygen Sensor)>P0115).

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0116 Engine Coolant Temperature Circuit Range/Performance Problem All of following conditions met (2 trip detection logic):
·

Engine speed of 1,000 rpm or more for 10 minutes or more

·

Engine coolant temperature does not reach 40°C (104°F)


·

Thermostat

·

Engine coolant temperature sensor

·

Cooling system


Comes on DTC stored

CAUTION / NOTICE / HINT

HINT:
·

If DTC P0115 is set simultaneously with DTC P0116, the Engine coolant temperature sensor may have an open or a short circuit. Troubleshoot the DTC P0115 first.

·

Read freeze frame data using the intelligent tester or Techstream. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.



PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116)
a.

Connect the intelligent tester or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester or Techstream on.


d.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 206

e.

Read DTCs.

Result:
Result Proceed to
P0116 A
P0116 and other DTCs B


HINT:

If any DTCs other than P0116 are output, troubleshoot those DTCs first.




A

2.INSPECT THERMOSTAT

B

2.INSPECT THERMOSTAT
a.

b.

Check the valve opening temperature of the thermostat.

Standard:

78°C to 82°C (172°F to 180°F)


HINT:

In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.



c.

Reinstall the thermostat.

Click hereEngine / Hybrid System>3SZ-VE COOLING>THERMOSTAT>INSTALLATION

Result:
Proceed to
OK
NG




OK

3.CHECK COOLING SYSTEM

NG

3.CHECK COOLING SYSTEM
a.

Check for defects in the cooling system that might cause the system to be too cold, such as abnormal radiator fan operation or any modifications.

Result:
Proceed to
OK
NG




OK

NG

REPAIR OR REPLACE COOLING SYSTEM