Home › Engine / Hybrid System › 3SZ-VE ENGINE CONTROL › HEATED OXYGEN SENSOR(w/ Rear Heated Oxygen Sensor) › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002968 3SZ-VE ENGINE CONTROL _0014990 HEATED OXYGEN SENSOR(w/ Rear Heated Oxygen Sensor) A

3SZ-VE ENGINE CONTROL  HEATED OXYGEN SENSOR(w/ Rear Heated Oxygen Sensor)  INSTALLATION  


PROCEDURE

Hide 89465A 1.INSTALL HEATED OXYGEN SENSOR (for Sensor 2)

A268886C01
1.323,0.458 1.323,0.323 1.323,0.323 1.042,0.323 true 0.75,0.24 1.052,0.406 0.302,0.167 10 SST 2.438,0.646 2.615,0.813 0.177,0.167 10 *1
*1 Fulcrum Length


a.

Using SST, install the heated oxygen sensor.

SST
09224-00010  

Torque:
without SST : 34 N*m (347 kgf*cm, 25 ft.*lbf)
with SST : 31 N*m (316 kgf*cm, 23 ft.*lbf)

NOTICE:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification. (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)

·

Make sure SST and the wrench are connected in a straight line.




b.

Connect the heated oxygen sensor connector.


Hide 89465 2.INSTALL HEATED OXYGEN SENSOR (for Sensor 1)

A266480C01
1.781,1.292 2.354,1.552 false 2.188,0.167 2.594,0.531 0.406,0.365 10 *1 2.438,1.531 3.083,1.917 0.646,0.385 10 SST
*1 Fulcrum Length


a.

Using SST, install the heated oxygen sensor.

SST
09224-00010  

Torque:
without SST : 34 N*m (347 kgf*cm, 25 ft.*lbf)
with SST : 31 N*m (316 kgf*cm, 23 ft.*lbf)

NOTICE:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification. (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)

·

Make sure SST and the wrench are connected in a straight line.




b.

Connect the heated oxygen sensor connector.


Hide 3.INSPECT FOR EXHAUST GAS LEAK