13751
1.REMOVE VALVE LIFTER
Keep the removed parts in the correct order so that they can be returned to their original positions when reassembled.
15678A
2.REMOVE OIL CONTROL VALVE FILTER
Using an 8 mm hexagon wrench, remove the No. 1 taper screw plug with head.
Remove the oil control valve filter and gasket.
13711
3.REMOVE INTAKE VALVE
Using SST, remove the retainer lock, then remove the retainer, compression spring and intake valve.
Keep the removed parts in the correct order so that they can be returned to their original positions when reassembled.
13715
4.REMOVE EXHAUST VALVE
Using SST, remove the retainer lock, then remove the retainer, compression spring and exhaust valve.
Keep the removed parts in the correct order so that they can be returned to their original positions when reassembled.
13711A
5.REMOVE VALVE STEM OIL O SEAL OR RING
Using needle-nose pliers, remove the valve stem oil o seal or ring.
13734
6.REMOVE VALVE SPRING SEAT
Using a magnetic finger and compression air, remove the valve spring seat.
7.REMOVE UNION
8.REMOVE STUD BOLT
Remove the 8 stud bolts.
9.REMOVE RING PIN
10.REMOVE TIGHT PLUG