Home › Engine / Hybrid System › 3SZ-VE ENGINE MECHANICAL › CYLINDER HEAD › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002969 3SZ-VE ENGINE MECHANICAL _0015000 CYLINDER HEAD A

3SZ-VE ENGINE MECHANICAL  CYLINDER HEAD  REPAIR  


PROCEDURE

Hide 1.REPAIR VALVE SEATS

A137177C04
2.865,0.281 3.26,0.646 0.396,0.365 10 45° 3.073,0.719 3.427,1.083 0.354,0.365 10 20° 2.354,1.833 2.688,2.125 0.333,0.292 10 *a
*a 1.0 to 1.4 mm (0.0394 to 0.0551 in.)


NOTICE:

Gradually release the seat cutter pressure to make the valve seat surface smoother.


a.

If the valve seating is too high on the valve face, use 20° and 45° cutters to correct the valve seat.


b.
A137178C04
2.917,0.417 3.26,0.76 0.344,0.344 10 45° 2.333,0.083 2.75,0.427 0.417,0.344 10 75° 2.365,1.906 2.781,2.177 0.417,0.271 10 *a
*a 1.0 to 1.4 mm (0.0394 to 0.0551 in.)


If the valve seating is too low on the valve face, use 45° and 75° cutters to correct the valve seat.


c.

Lap the valve and valve seat with an abrasive compound.


d.

Recheck the valve seating surface.