Home › Engine / Hybrid System › K3-VE ENGINE MECHANICAL › CYLINDER HEAD › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002970 K3-VE ENGINE MECHANICAL _0015011 CYLINDER HEAD A

K3-VE ENGINE MECHANICAL  CYLINDER HEAD  REPLACEMENT  


PROCEDURE

Hide 1.REMOVE VALVE GUIDE BUSH

A263115

a.

Heat the cylinder head up to between 80 and 100°C.


b.
A143081

Using SST, tap the valve guide bush out from the combustion chamber side.

SST
09201-10000  (09201-01050)
09950-70010  (09951-07100)


Hide 2.INSTALL VALVE GUIDE BUSH

a.

Heat the cylinder head up to between 80 and 100°C.

SST
09201-10000  (09201-01050)
09950-70010  (09951-07100)


b.
A143117E04
2.396,3.51 3.427,3.917 1.031,0.406 10 14.2 to 14.8 mm

Using SST, tap in a new valve guide bush until its protrusion height is as specified.

Protrusion height:

14.2 to 14.8 mm (0.559 to 0.583 in.)


NOTICE:
·

If the valve guide bush is removed, use an oversized bush (service part).

·

Be careful not to tap in the valve guide bush too far. While tapping in the valve guide bush, always check the protrusion height.