Home › Engine / Hybrid System › K3-VE ENGINE MECHANICAL › CYLINDER HEAD › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002970 K3-VE ENGINE MECHANICAL _0015011 CYLINDER HEAD A

K3-VE ENGINE MECHANICAL  CYLINDER HEAD  REPAIR  


PROCEDURE

Hide 1.REPAIR VALVE SEATS

A137177C03
2.833,0.229 3.344,0.552 0.51,0.323 10 45° 3.052,0.729 3.427,1.073 0.375,0.344 10 20° 2.417,1.833 2.781,2.156 0.365,0.323 10 *a
*a 1.0 to 1.4 mm (0.0394 to 0.0551 in.)


NOTICE:

Gradually release the seat cutter pressure to make the valve seat surface smoother.


a.

If the valve seating is too high on the valve face, use 20° and 45° cutters to correct the valve seat.


b.
A137178C03
2.927,0.469 3.354,0.771 0.427,0.302 10 45° 2.323,0.063 2.76,0.344 0.438,0.281 10 75° 2.396,1.896 2.74,2.177 0.344,0.281 10 *a
*a 1.0 to 1.4 mm (0.0394 to 0.0551 in.)


If the valve seating is too low on the valve face, use 45° and 75° cutters to correct the valve seat.


c.

Lap the valve and valve seat with an abrasive compound.


d.

Recheck the valve seating surface.