Home › Engine / Hybrid System › 3SZ-VE FUEL › FUEL PUMP › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002971 3SZ-VE FUEL _0015013 FUEL PUMP G

3SZ-VE FUEL  FUEL PUMP  INSPECTION  


PROCEDURE

Hide 23210P 1.INSPECT FUEL PUMP ASSEMBLY

a.
A285398C02
0.135,0.094 0.448,0.292 0.313,0.198 10 *a 1.271,1.438 1.427,1.635 0.156,0.198 10 1 2.135,1.448 2.292,1.646 0.156,0.198 10 2
*a Component without harness connected
(Fuel Pump Assembly)


Check the resistance of the fuel pump.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Specified Condition
1 - 2 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel pump.



b.

Inspect the operation of the fuel pump.

i.

Connect the positive battery (+) lead to terminal 1 of the connector, and the negative (-) lead to terminal 2. Check that the fuel pump operates.

If the pump does not operate, replace the fuel pump.

NOTICE:
·

These tests must be performed within 10 seconds of connecting the battery to prevent the coil from burning out.

·

Keep the fuel pump as far away from the battery as possible.

·

Turn the voltage on and off on the battery side, not the fuel pump side.