Home › Engine / Hybrid System › 3SZ-VE FUEL › FUEL SENDER GAUGE ASSEMBLY › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002971 3SZ-VE FUEL _0015015 FUEL SENDER GAUGE ASSEMBLY G

3SZ-VE FUEL  FUEL SENDER GAUGE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 83320 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

a.

Check that the float moves smoothly between F and E.


b.
E236810C04
0.198,0.198 0.385,0.375 0.188,0.177 10 *a 0.365,2.479 0.49,2.625 0.125,0.146 10 F 0.583,4.354 0.708,4.5 0.125,0.146 10 E 0.229,3.385 0.458,3.531 0.229,0.146 10 1/2
*a Component without harness connected
(Fuel Sender Gauge Assembly)


Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
1 - 2 F (Upper End) 13.5 to 16.5 Ω
1 - 2 1/2 176.9 to 201.9 Ω
1 - 2 E (Lower End) 405.5 to 414.5 Ω


If the result is not as specified, replace the fuel sender gauge assembly.