23250
1.INSPECT FUEL INJECTOR ASSEMBLY
| *1 | Ohmmeter |
| *a | Component without harness connected
(Fuel Injector Assembly) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68 °F) | 11.6 to 12.4 Ω |
If the resistance is not as specified, replace the fuel injector.
After replacing the injector assembly, perform the "inspection after repairs"
Check the operation.
Perform the inspection in a well-ventilated area. Do not perform the inspection near any flames.
| *1 | Fuel Pipe |
| *2 | Retainer |
| *3 | O-ring |
SST (connector) seals the fuel tube connector and pipe with an O-ring.
Ensure that there is no damage or foreign matter on the contact surface.
| *1 | O-ring |
| *2 | Vinyl tube |
| *3 | SST (Clamp) |
| *4 | SST (Clip) |
| *5 | SST (Adapter) |
Install the O-ring onto the fuel injector.
Connect SST (fuel tube connector) to SST (hose), and then connect them to the fuel pipe (vehicle side).
Install a new O-ring onto the fuel injector.
Connect SST (adapter and hose) to the fuel injector assembly, and hold the fuel injector assembly and union with SST (clamp).
Connect SST (a hose) to No. 1 fuel pipe.
Set the fuel injector in a graduated cylinder.
Actuate the fuel pump.
Install SST onto the fuel injector.
Connect SST onto the battery, and measure the injection volume for 15 seconds. Perform the inspection 2 or 3 times, then calculate the average.
| Injection Volume | Difference between fuel injectors |
|---|---|
| 47 to 58 cm3 (2.9 to 3.5 cu in.) per 15 sec. | 11 cm3 (0.7 cu in.) or less |
Always do the switching on the battery side.
If the result is not as specified, replace the fuel injector.
Check the leakage.
If inspecting the injection volume, remove SST from the battery. Inspect the fuel leakage from the injector.
1 drop or less every minute.
If the result is not as specified, replace the fuel injector.