Home › Engine / Hybrid System › K3-VE FUEL › FUEL INJECTOR › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002972 K3-VE FUEL _0015021 FUEL INJECTOR A

K3-VE FUEL  FUEL INJECTOR  INSTALLATION  


PROCEDURE

Hide 23250 1.INSTALL FUEL INJECTOR ASSEMBLY

a.
A126553C04
2.271,1.865 2.271,1.646 false 0.792,1.365 0.792,1.156 false 2.167,1.885 2.375,2.063 0.208,0.177 10 *2 0.708,1.396 0.917,1.552 0.208,0.156 10 *1
*1 Insulator
*2 O-ring


Install a new injector vibration insulator and O-ring onto the fuel injector.


b.

Apply a light coat of spindle oil or gasoline to the new O-ring.


c.
A126554

Install the fuel injector onto the fuel delivery pipe while turning it right and left.

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing.



d.

Check that the fuel injector rotates smoothly.

NOTICE:

If the fuel injector does not rotate, replace the O-ring with a new one.



e.

Adjust the fuel injector connector so that it faces upward.


Hide 23845C 2.INSTALL FUEL PIPE INSULATOR

a.

Install the 2 fuel pipe insulators.


Hide 23807 3.INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY

a.

Place the fuel delivery pipe on the cylinder head with the fuel injector installed onto the fuel delivery pipe.


b.

Hold the fuel delivery pipe and temporarily install it onto the cylinder head with the 2 bolts.

NOTICE:

Do not drop the fuel injector when installing the fuel delivery pipe.



c.
A126555

A126556

Check that the fuel injector rotates smoothly.

If not, the O-ring is probably installed incorrectly.


d.

Adjust the fuel injector connector so that it faces upward.


e.

Tighten the 2 bolts to the specified torque.

Torque:
21 N*m (214 kgf*cm, 16 ft.*lbf)


f.

Connect the 4 fuel injector connectors.


g.

Install the 2 clamps of the engine wire.


Hide 4.CONNECT FUEL TUBE SUB-ASSEMBLY

a.
A263491

Line up the pipe and connector and push them together until a "click" sound is heard.

NOTICE:
·

Check that there are no scratches or foreign objects on the connecting part.

·

If the pipe is difficult to push into the connector, apply a small amount of clean engine oil to the tip of the pipe and reinsert it.

·

After connecting, check that the pipe and connector are securely connected by pulling on them.




Hide 5.INSTALL NO. 2 FUEL PIPE CLAMP

a.

Install the No. 2 fuel pipe clamp


Hide 12261 6.CONNECT VENTILATION HOSE

a.

Connect the ventilation hose to the ventilation valve.


Hide 22210 7.INSTALL THROTTLE BODY ASSEMBLY

Hide 8.INSPECT FOR FUEL LEAK