1. DISCHARGE FUEL SYSTEM PRESSURE
22210
2.REMOVE THROTTLE BODY ASSEMBLY
12261
3.REMOVE VENTILATION HOSE
Disconnect the ventilation hose from the ventilation valve.
4.REMOVE NO. 2 FUEL PIPE CLAMP
Remove the No. 2 fuel pipe clamp.
5.DISCONNECT FUEL TUBE SUB-ASSEMBLY
Pinch the tube connector and pull out the fuel pipe (See page Engine / Hybrid System>K3-VE FUEL>FUEL SYSTEM>PRECAUTION).
Check for dirt or other foreign matter on the parts to be disconnected and clean them if necessary.
The fuel tube connector seals with an O-ring. Ensure that there is no damage or foreign matter on the contact surface.
If the connector and the pipe are stuck, push and pull on the connector to release them while pinching the retainer. Pull the connector out of the pipe carefully.
Do not use any tools.
Do not bend or twist the tubes.
Protect the contact surface by covering it with a plastic bag.
Do not damage any of the clips. If a clip is damaged, replace it.
23807
6.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY
Disengage the 2 clamps of the engine wire.
Disconnect the 4 fuel injector connectors.
Remove the 2 bolts, then remove the fuel delivery pipe together with the fuel injector.
Do not drop the fuel injector when removing the fuel delivery pipe.
23845C
7.REMOVE FUEL PIPE INSULATOR
Remove the 2 fuel pipe insulators.
23250
8.REMOVE FUEL INJECTOR ASSEMBLY
Remove the 4 fuel injectors from the fuel delivery pipe.
For reinstallation, attach a tag or label to each injector shaft.
Prevent entry of foreign objects by covering the fuel injectors with plastic bags.
23291
9.REMOVE INJECTOR VIBRATION INSULATOR
Using a screwdriver, remove the 4 injector vibration insulators from the cylinder head.