Home › Engine / Hybrid System › 3SZ-VE EMISSION CONTROL › CANISTER › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002973 3SZ-VE EMISSION CONTROL _0015026 CANISTER A

3SZ-VE EMISSION CONTROL  CANISTER  REMOVAL  


PROCEDURE

Hide 77740 1.REMOVE CHARCOAL CANISTER ASSEMBLY

A268980C03
1.51,0.677 1.25,0.448 true 1.865,1.083 2.604,1.51 true 1.302,1.208 0.49,0.896 true 2.656,1.469 2.885,1.667 0.229,0.198 10 *1 1.135,0.281 1.354,0.469 0.219,0.188 10 *2 0.292,0.813 0.51,1.021 0.219,0.208 10 *3 0.083,0.083 0.396,0.281 0.313,0.198 10 *A
*A w/o Rear Heated Oxygen Sensor
*1 Charcoal Canister Hose
*2 Evapo Hose
*3 No. 2 Charcoal Canister Outlet Hose


A275334C01
0.823,1.885 1.083,1.74 false 1.771,0.229 1.771,0.688 true 2.208,0.875 2.771,1.24 true 0.083,0.083 0.323,0.292 0.24,0.208 10 *B 2.813,1.188 3.01,1.354 0.198,0.167 10 *1 1.698,0.063 1.896,0.229 0.198,0.167 10 *2 0.646,1.823 0.844,1.99 0.198,0.167 10 *3
*B w/ Rear Heated Oxygen Sensor for LHD
*1 Charcoal Canister Hose
*2 Evapo Hose
*3 No. 2 Charcoal Canister Outlet Hose


a.

Disconnect the charcoal canister hose and No. 2 charcoal canister outlet hose to the charcoal canister assembly.


b.

Loosen the hose clamp, then disconnect the evapo hose to the charcoal canister assembly.


c.

Remove the charcoal canister assembly from the vehicle by pulling it up.