Home › Engine / Hybrid System › K3-VE EMISSION CONTROL › EMISSION CONTROL SYSTEM › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002974 K3-VE EMISSION CONTROL _0015031 EMISSION CONTROL SYSTEM G

K3-VE EMISSION CONTROL  EMISSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL CUT OFF RPM

a.

Increase the engine speed to approximately 3000 rpm.


b.

Using a sound scope, check the operation sounds of the injector.


c.

Release the throttle lever. Check that the operation sounds stop momentarily and then resume.


Hide 2.VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS

a.
A126557

Check that there are no cracks, leakage or scratches on the hoses, connections and gaskets.

HINT:
·

Removal of the oil level gauge, oil filler cap or PCV hose may cause the engine to malfunction or engine stall.

·

Disconnection, slack or cracks in the parts of the air induction system between the intake system and cylinder head will allow air suction and cause the engine to run improperly.