Home › Engine / Hybrid System › K3-VE COOLING › COOLING SYSTEM › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002977 K3-VE COOLING _0015043 COOLING SYSTEM G

K3-VE COOLING  COOLING SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT COOLING SYSTEM FOR LEAK

A143086

a.

Remove the radiator cap sub-assembly.

NOTICE:

To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.



b.

Fill the radiator with coolant and attach a radiator cap tester.


c.

Warm up the engine.


d.

Pump it to 122.7 kPa (1.3 kgf/cm2, 17.8 psi), then check that the pressure does not drop. If the pressure drops, check the hoses, radiator and water pump for leakage. If there are no signs of external coolant leakage, check the heater core, cylinder block and head.


e.

Reinstall the radiator cap sub-assembly.


Hide 2.CHECK ENGINE COOLANT LEVEL OF RESERVOIR

A261256

a.

The engine coolant level should be between the LOW and FULL lines when the engine is cold. If low, check for leakage and add Toyota Super Long Life Coolant or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology up to the FULL line.


Hide 3.CHECK ENGINE COOLANT QUALITY

a.

Remove the radiator cap sub-assembly.

CAUTION:

To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.



b.

Check for any excessive deposits of rust or scale around the radiator cap sub-assembly and radiator filler hole; the coolant should be free of oil. If excessively dirty, replace the coolant.


c.

Reinstall the radiator cap sub-assembly.