Home › Engine / Hybrid System › K3-VE COOLING › COOLING FAN SYSTEM › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002977 K3-VE COOLING _0015044 COOLING FAN SYSTEM G

K3-VE COOLING  COOLING FAN SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK COOLING FAN OPERATION AT LOW TEMPERATURE (Below 83°C (181°F))

a.

Check that the cooling fan does not rotate when the ignition switch is turned to ON with the A/C switch off.


b.

Disconnect the engine coolant temperature sensor connector, then turn the ignition switch to ON. Check that the cooling fan rotates.


Hide 2.CHECK COOLING FAN OPERATION AT HIGH TEMPERATURE (Above 98°C (208°F))

a.

Warm up the engine and check that the A/C switch is off.


b.

Check that the cooling fan starts rotating when the coolant temperature is higher than 98°C (208°F) and that it stops rotating when the coolant temperature is lower than 95°C (204°F).

NOTICE:

The coolant temperature is sensed by the engine coolant temperature sensor on the water outlet (engine outlet) of the cylinder head.



Hide 3.INSPECT COOLING FAN MOTOR

A269815C01
2.344,0.542 2.833,0.938 0.49,0.396 10 *a 0.719,1.708 1.125,2.052 0.406,0.344 10 *b
*a Ammeter
*b Battery


a.

Disconnect the cooling fan motor connector.


b.

Check that the cooling fan rotates smoothly when the battery is connected to the fan motor connector.


c.

Using an ammeter, measure the current with step (b) maintained.

Standard current:

6.4 to 9.4 A at 20°C (68°F) for 80W Fan Motor

10.0 to 15.0 A at 20°C (68°F) for 160W Fan Motor



d.

Connect the cooling fan motor connector.