Home › Engine / Hybrid System › K3-VE COOLING › THERMOSTAT › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002977 K3-VE COOLING _0015047 THERMOSTAT A

K3-VE COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 16331A 1.INSTALL THERMOSTAT

a.

Install a new gasket onto the thermostat.


b.
A143103C02
2.292,0.75 2.594,0.229 true 1.104,0.885 1.375,1.25 true 0.854,0.729 1.25,1.063 0.396,0.333 10 *1 2.635,0.083 2.99,0.406 0.354,0.323 10 *a
*1 Jiggle Pin
*a Protrusion


Align the thermostat so the jiggle pin faces upward. Align the jiggle pin with the protrusion of the water inlet, then install the thermostat onto the water inlet.


Hide 16321 2.INSTALL WATER INLET

a.

Install the water inlet with the bolt and nut.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


b.

Install the wiring harness clamp bracket with the bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 16573B 3.INSTALL NO. 3 RADIATOR HOSE

a.

Tighten the No. 1 air cleaner hose clamp.


b.

Connect the No. 3 radiator hose.


Hide 4.INSTALL ENGINE AND TRANSMISSION ASSEMBLY