1.INSPECT FOR FIN FOR BLOCKAGE
If the fins are clogged, wash them with water or a steam cleaner and then dry them with compressed air.
If the distance between the steam cleaner and core is too small, the fins may be damaged. So, keep to the following injection distance.
| Injection Pressure
kPa (kgf/cm2, psi) |
Injection Distance
mm (in.) |
| 2942 to 4903
(30 to 50, 427 to 711) |
300 (11.811) |
| 4903 to 7845
(50 to 80, 711 to 1138) |
500 (19.685) |
If the fins are bent, straighten them using a screwdriver or pliers.
Do not expose electronic components to water.