Home › Engine / Hybrid System › K3-VE COOLING › RADIATOR › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002977 K3-VE COOLING _0015048 RADIATOR G

K3-VE COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16401 1.INSPECT FOR RADIATOR CAP SUB-ASSEMBLY

a.
A138101

Measure the valve opening pressure.

i.

If there are water stains or foreign matter on rubber packings 1, 2 or 3, clean the part(s) with water and finger scouring.


ii.

Check that rubber packings 1, 2 and 3 are not deformed, cracked or swollen.


iii.

Check that rubber packings 3 and 4 are not stuck together.


iv.

Apply engine coolant to rubber packings 2 and 3 before using the radiator cap tester.


v.

When using the cap tester, tilt it to more than 30 degrees.


vi.
A143091C02
2.083,0.396 1.74,0.896 false 0.479,0.979 0.667,1.479 true 2.063,0.25 2.49,0.594 0.427,0.344 10 *1 0.635,1.552 0.979,1.927 0.344,0.375 10 *2 1.781,1.177 2.188,1.542 0.406,0.365 10 *a
*1 Radiator Cap Tester
*2 Radiator Cap Sub-assembly
*a 30°or more


Pump the cap tester several times, and check the maximum pressure *1.

Pumping speed:

1 pump per second


*1: Even if the cap cannot maintain the maximum pressure, it is not a defect.

Judgement criteria:
Item Specified Condition
Standard value (for brand new cap) 93 to 123 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
Minimum standard value (used cap) 78 kPa (0.8 kgf/cm2, 11.3 psi)


If the maximum pressure is less than the specified pressure for the minimum standard value, replace the radiator cap sub-assembly.