Home › Engine / Hybrid System › K3-VE LUBRICATION › LUBRICATION SYSTEM › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002980 K3-VE LUBRICATION _0015063 LUBRICATION SYSTEM G

K3-VE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK ENGINE OIL LEVEL

a.

Warm up and stop the engine, and then wait for 5 minutes.


b.

Check that the engine oil level is between the low level and full level marks on the engine oil level dipstick.

If low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not fill with engine oil above the full level mark.



Hide 2.CHECK ENGINE OIL QUALITY

a.

Check the oil for deterioration, entry of water, discoloring or thinning.

If the quality is visibly poor, replace the oil.


Hide 3.INSPECT OIL PRESSURE

a.

Remove the oil pressure switch assembly (See page Engine / Hybrid System>K3-VE LUBRICATION>OIL PRESSURE SWITCH>REMOVAL).


b.
A143106

Install the oil pressure gauge.


c.

Warm up engine.


d.

Check the oil pressure. If the oil pressure is not as specified, check the oil pump.

Oil Pressure:
At Idle At 3000 rpm
39 kPa (0.4 kgf/cm2, 5.7 psi) or more 225 kPa (2.3 kgf/cm2, 32.6 psi)



e.

Remove the oil pressure gauge.


f.

Install the oil pressure switch assembly (See page Engine / Hybrid System>K3-VE LUBRICATION>OIL PRESSURE SWITCH>INSTALLATION).


g.

Check for the engine oil leaks.