Home › Engine / Hybrid System › 3SZ-VE STARTING › IGNITION SWITCH › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002981 3SZ-VE STARTING _0015069 IGNITION SWITCH G

3SZ-VE STARTING  IGNITION SWITCH  INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RHD and LHD sides.

·

The procedure described below is for the LHD side.



PROCEDURE

Hide 84450 1.INSPECT IGNITION OR STARTER SWITCH ASSEMBLY

a.
A261460C01
1.094,0.719 1.406,0.417 true 0.844,0.76 0.521,0.76 true 1.615,0.76 1.292,0.76 true 0.854,0.927 0.51,1.219 true 1.073,0.938 1.073,1.271 true 1.281,0.927 1.552,1.198 true 0.188,0.083 0.594,0.427 0.406,0.344 10 *a 2.208,1.313 2.542,1.625 0.333,0.313 10 *b 2.969,1.698 3.344,2.083 0.375,0.385 10 *c 3.125,2.281 3.427,2.594 0.302,0.313 10 *d 2.979,3 3.333,3.26 0.354,0.26 10 *e 0.177,0.688 0.729,1.01 0.552,0.323 10 ACC 1.438,0.25 1.906,0.594 0.469,0.344 10 IG1 1.667,0.677 2.188,1.052 0.521,0.375 10 AM 1.552,1.198 2,1.563 0.448,0.365 10 ST 0.906,1.302 1.438,1.625 0.531,0.323 10 AM2 0.26,1.198 0.719,1.521 0.458,0.323 10 IG2
*a Component without harness connected
(Ignition Or Starter Switch Assembly)
*b LOCK
*c ACC
*d ON
*e START


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
Between all terminals LOCK 1 MΩ or higher
1 (AM) - 3 (ACC) ACC Below 1 Ω
1 (AM1) - 2 (IG1) - 3 (ACC) ON Below 1 Ω
5 (AM2) - 6 (IG2)
1 (AM) - 2 (IG1) START Below 1 Ω
4 (ST) - 5 (AM2) - 6 (IG2)


If the result is not as specified, replace the ignition or starter switch assembly.