Use the same procedure for both the RHD and LHD sides.
The procedure described below is for the LHD side.
84450
1.INSPECT IGNITION OR STARTER SWITCH ASSEMBLY
| *a | Component without harness connected
(Ignition Or Starter Switch Assembly) |
| *b | LOCK |
| *c | ACC |
| *d | ON |
| *e | START |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| Between all terminals | LOCK | 1 MΩ or higher |
| 1 (AM) - 3 (ACC) | ACC | Below 1 Ω |
| 1 (AM1) - 2 (IG1) - 3 (ACC) | ON | Below 1 Ω |
| 5 (AM2) - 6 (IG2) | ||
| 1 (AM) - 2 (IG1) | START | Below 1 Ω |
| 4 (ST) - 5 (AM2) - 6 (IG2) |
If the result is not as specified, replace the ignition or starter switch assembly.