Home › Engine / Hybrid System › K3-VE STARTING › STARTER(for Manual Transmission) › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002982 K3-VE STARTING _0015076 STARTER(for Manual Transmission) A

K3-VE STARTING  STARTER(for Manual Transmission)  DISASSEMBLY  


PROCEDURE

Hide 28150 1.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A142238

Remove the nut, then disconnect the lead wire from the magnet starter switch terminal.


b.
A142239

Remove the 2 nuts.


c.
A142240C07
1.719,0.625 1.719,0.25 1.719,0.25 1.385,0.25 false 2.26,0.583 2.833,0.583 true 1.167,0.156 1.781,0.583 0.615,0.427 10 *1 2.906,0.49 3.26,0.792 0.354,0.302 10 *2
*1 Plunger
*2 Starter Pinion Drive Lever


Remove the plunger from the starter pinion drive lever while lifting the magnet switch front, then remove the magnet starter switch assembly.


Hide 28120 2.REMOVE STARTER YOKE ASSEMBLY

a.
A142241

Remove the 2 through bolts, then remove the starter yoke assembly and starter pinion drive lever.


b.
A142242C04
1.24,0.531 1.021,0.344 true 0.802,0.219 1.385,0.552 0.583,0.333 10 *1
*1 Lead Wire


Remove the starter commutator end frame assembly.

NOTICE:

Remove it while pushing the lead wire to the starter yoke assembly side.



c.

Clamp the starter armature assembly shaft in a vise.

NOTICE:

Do not clamp it in a vise too tightly.



d.
A142243

Remove the brush holder insulator.


e.
A142244

Remove the 4 brush springs.

NOTICE:

Do not allow the brush springs to fly off.



f.
A142245

Remove the starter brush holder assembly.


g.

Remove the starter yoke assembly from the starter armature assembly.


Hide 28011 3.REMOVE STARTER CLUTCH SUB-ASSEMBLY

a.

Clamp the starter armature assembly in a vise.

NOTICE:

Do not clamp it too tightly in the vise.



b.

Remove the starter pinion stop nut (outer).


c.
A142246

Using a screwdriver, tap the starter pinion stop nut (inner) to the starter clutch sub-assembly side.


d.
A142247

Using a screwdriver, remove the snap ring.


e.

Remove the starter pinion stop nut (inner) and starter clutch sub-assembly from the starter armature assembly.


Hide 28199A 4.REMOVE DUST STARTER PROTECTOR

a.
A142248

Remove the dust starter protector from the starter commutator end frame assembly.