Home › Drivetrain › A4Q AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM › 2011.11–2015.08
RM19Y0E _52 Drivetrain _002983 A4Q AUTOMATIC TRANSMISSION / TRANSAXLE _0015077 AUTOMATIC TRANSMISSION SYSTEM D

A4Q AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  MANUAL SHIFTING TEST  


PERFORM MANUAL SHIFTING TEST


HINT:
·

This test can be used to determine whether the trouble is occurring in the electrical circuit or is a mechanical problem in the transmission.

·

If any abnormalities are found in the following test, the problem is in the transmission itself.



a.
C246637

Disconnect the solenoid wire connector.

HINT:

It is possible to deactivate the electrical shift control by disconnecting the solenoid wire. In this way, it is possible to change gear positions mechanically by using the shift lever.



b.

Drive with the solenoid wire disconnected. Shift the shift lever into each position to check whether the gear position changes as shown in the table below.

Shift Position Shifting Condition
D 3rd
3 3rd
2 3rd
L 3rd
R Reverse
P Pawl Lock


c.

Connect the solenoid wire connector.