Home › Drivetrain › A4Q AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH › 2011.11–2015.08
RM19Y0E _52 Drivetrain _002983 A4Q AUTOMATIC TRANSMISSION / TRANSAXLE _0015081 PARK / NEUTRAL POSITION SWITCH A

A4Q AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


PROCEDURE

Hide 33820B 1.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.
C267371

Remove the bolt and disconnect the transmission control cable assembly.

NOTICE:

Do not excessively bend the flexible sections at the ends of the transmission control cable assembly.



b.
C153886

Remove the clip and disconnect the transmission control cable assembly from the control cable bracket.


Hide 35507D 2.REMOVE TRANSMISSION CONTROL SHAFT LEVER

a.

Move the shift lever to N.


b.
C248808C02
3.01,0.938 3.24,0.969 false 3.229,0.875 3.427,1.354 0.198,0.479 10 *1
*1 Transmission Control Shaft Lever


Remove the nut and transmission control shaft lever.


Hide 84540 3.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

C136924

a.

Disconnect the connector.


b.

Remove the bolt and pull out the park/neutral position switch assembly.

HINT:

Make sure that the manual valve lever sub-assembly has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever sub-assembly.