1.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS
Loosen the lock nut and remove the clutch master cylinder push rod clevis from the clutch master cylinder push rod.
Remove the lock nut from the clutch master cylinder push rod.
2.REMOVE MASTER CYLINDER PISTON SUB-ASSEMBLY
Using snap ring pliers, remove the snap ring while pushing the clutch master cylinder push rod.
Remove the clutch master cylinder push rod from the cylinder body.
Remove the piston stop plate from the clutch master cylinder push rod.
Remove the master cylinder piston sub-assembly and spring from the cylinder body.
Do not damage the inside of the cylinder body.
Remove the 2 cylinder cups from the master cylinder piston sub-assembly.
3.REMOVE MASTER CYLINDER INLET UNION
Using a pin punch and hammer, tap out the spring pin.
Remove the master cylinder inlet union and clutch reservoir grommet.