1.INSTALL MASTER CYLINDER INLET UNION
Apply lithium soap base glycol grease to the new clutch reservoir grommet.
Install a clutch reservoir grommet and the master cylinder inlet union.
| *a | 1.5 to 3.5 mm (0.059 to 0.138 in.) |
Using a pin punch and hammer, tap in the spring pin.
2.INSTALL MASTER CYLINDER PISTON SUB-ASSEMBLY
Install 2 new cylinder cups onto the master cylinder piston sub-assembly.
Apply lithium soap base glycol grease to the portions shown in the illustration.
Install the master cylinder piston sub-assembly and spring into the cylinder body.
Install the piston stop plate onto the clutch master cylinder push rod.
Install the clutch master cylinder push rod into the cylinder body.
Using snap ring pliers, install the snap ring while pushing the master cylinder push rod.
3.INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS
Install the lock nut onto the clutch master cylinder push rod.
Install the clutch master cylinder push rod clevis onto the clutch master cylinder push rod.