Home › Drivetrain › CLUTCH › CLUTCH UNIT(for 3SZ-VE) › 2011.11–2015.08
RM19Y0E _52 Drivetrain _002984 CLUTCH _0015096 CLUTCH UNIT(for 3SZ-VE) G

CLUTCH  CLUTCH UNIT(for 3SZ-VE)  INSPECTION  


PROCEDURE

Hide 31250 1.INSPECT CLUTCH DISC ASSEMBLY

C142539

a.

Using a vernier caliper, measure the rivet head depth.

Maximum rivet depth:

0.4 mm (0.016 in.)


If necessary, replace the clutch disc assembly.


b.
C142540

Using a dial indicator, check the clutch disc assembly runout.

Maximum runout:

1.0 mm (0.039 in.)


If necessary, replace the clutch disc assembly.


Hide 31210 2.INSPECT CLUTCH COVER ASSEMBLY

C142541N01
0.396,0.542 0.76,0.875 0.365,0.333 10 A 1.115,0.313 1.385,0.615 0.271,0.302 10 B

a.

Using a vernier caliper, inspect the depth and width of wear of the diaphragm spring.

Maximum:

A (Depth): 0.5 mm (0.020 in.)

B (Width): 6.0 mm (0.236 in.)


If necessary, replace the clutch cover assembly.


Hide 13405 3.INSPECT FLYWHEEL SUB-ASSEMBLY

C142542

a.

Using a dial indicator, inspect the flywheel sub-assembly runout.

Maximum runout:

0.1 mm (0.004 in.)


If necessary, replace the flywheel sub-assembly.


Hide 31230 4.INSPECT CLUTCH RELEASE BEARING ASSEMBLY

C142543

a.

Turn the clutch release bearing assembly by hand while applying force in the axial direction.

HINT:

The bearing is permanently lubricated and requires no cleaning or lubrication.

If necessary, replace the clutch release bearing assembly .