31250
1.INSPECT CLUTCH DISC ASSEMBLY
Using a vernier caliper, measure the rivet head depth.
0.4 mm (0.016 in.)
If necessary, replace the clutch disc assembly.
Using a dial indicator, check the clutch disc assembly runout.
1.0 mm (0.039 in.)
If necessary, replace the clutch disc assembly.
31210
2.INSPECT CLUTCH COVER ASSEMBLY
Using a vernier caliper, inspect the depth and width of wear of the diaphragm spring.
A (Depth): 0.5 mm (0.020 in.)
B (Width): 6.0 mm (0.236 in.)
If necessary, replace the clutch cover assembly.
13405
3.INSPECT FLYWHEEL SUB-ASSEMBLY
Using a dial indicator, inspect the flywheel sub-assembly runout.
0.1 mm (0.004 in.)
If necessary, replace the flywheel sub-assembly.
31230
4.INSPECT CLUTCH RELEASE BEARING ASSEMBLY
Turn the clutch release bearing assembly by hand while applying force in the axial direction.
The bearing is permanently lubricated and requires no cleaning or lubrication.
If necessary, replace the clutch release bearing assembly.