Home › Drivetrain › M5S MANUAL TRANSMISSION / TRANSAXLE › OUTPUT SHAFT › 2011.11–2015.08
RM19Y0E _52 Drivetrain _002985 M5S MANUAL TRANSMISSION / TRANSAXLE _0015108 OUTPUT SHAFT A

M5S MANUAL TRANSMISSION / TRANSAXLE  OUTPUT SHAFT  DISASSEMBLY  


PROCEDURE

Hide 33311D 1.REMOVE INPUT SHAFT BEARING

C150306

a.

Remove the input shaft bearing from the output shaft.


Hide 33367 2.REMOVE NO. 1 SYNCHRONIZER RING

C150307C02
2.552,0.583 2.313,0.583 false 2.594,0.5 2.802,0.677 0.208,0.177 10 *1
*1 Wave Spring


a.

Remove the wave spring from the No. 1 synchronizer ring.


b.

Remove the No. 1 synchronizer ring from the output shaft.


Hide 33321N 3.REMOVE RADIAL BALL BEARING

C150308N02
2.229,1.042 1.99,1.042 false 2.26,0.969 2.635,1.177 0.375,0.208 10 SST

a.

Using SST, remove the radial ball bearing.

SST
09950-40011  (09951-04010, 09952-04010, 09953-04010, 09954-04010, 09955-04011, 09958-04011)


Hide 33481 4.REMOVE SPEEDOMETER DRIVE GEAR

C150309

a.

Remove the speedometer drive gear from the output shaft.


Hide 33321A 5.REMOVE OUTPUT SHAFT CENTER BEARING

C150310

a.

Using a chisel and a hammer, loosen the staked part of the output shaft center bearing lock nut.


b.

Remove the output shaft center bearing lock nut.


c.
C150311N02
1.146,1.104 0.656,0.729 true 0.333,0.635 0.677,0.802 0.344,0.167 10 SST

Using SST and a press, remove the output shaft center bearing from the output shaft.

SST
09950-00020