Home › Drivetrain › M5S MANUAL TRANSMISSION / TRANSAXLE › OUTPUT SHAFT › 2011.11–2015.08
RM19Y0E _52 Drivetrain _002985 M5S MANUAL TRANSMISSION / TRANSAXLE _0015108 OUTPUT SHAFT A

M5S MANUAL TRANSMISSION / TRANSAXLE  OUTPUT SHAFT  REASSEMBLY  


PROCEDURE

Hide 33321A 1.INSTALL OUTPUT SHAFT CENTER BEARING

C150314N02
2.24,0.49 2,0.49 false 2.302,0.406 2.625,0.604 0.323,0.198 10 SST

a.

Using SST and a press, install the output shaft center bearing to the output shaft.

SST
09612-22011  


b.
C150315N03
2.54,0.493 2.911,0.684 0.372,0.191 10 SST 2.337,0.764 2.509,0.591 false

Using SST, install a new output shaft center bearing lock nut.

SST
09922-10010  

Torque:
for use without SST : 196 N*m (1999 kgf*cm, 145 ft.*lbf)
for use with SST : 147 N*m (1499 kgf*cm, 108 ft.*lbf)

NOTICE:

When installing the SST to the lock nut, securely tighten the hexagon part of the SST adjusting screw with a wrench and then tighten the lock nut.


HINT:

Use a torque wrench with a fulcrum length of 425 mm (16.73 in.).



c.
C150316

Using a chisel and a hammer, stake the output shaft center bearing lock nut.


Hide 33481 2.INSTALL SPEEDOMETER DRIVE GEAR

C150309

a.

Install the speedometer drive gear to the output shaft.


Hide 33321N 3.INSTALL RADIAL BALL BEARING

C150509N02
2.083,1.083 1.844,1.083 false 2.115,1.01 2.469,1.156 0.354,0.146 10 SST

a.

Using SST and a press, install the radial ball bearing.

SST
09612-22011  


Hide 33367 4.INSTALL NO. 1 SYNCHRONIZER RING

C150510

a.

Install the No. 1 synchronizer ring to the output shaft.


b.

Install the wave spring to the No. 1 synchronizer ring.


Hide 33311D 5.INSTALL INPUT SHAFT BEARING

C150306

a.

Coat the input shaft bearing with MP grease.


b.

Install the input shaft bearing to the output shaft.