Home › Drivetrain › M5S MANUAL TRANSMISSION / TRANSAXLE › SPEEDOMETER SENSOR(w/o ABS) › 2011.11–2015.08
RM19Y0E _52 Drivetrain _002985 M5S MANUAL TRANSMISSION / TRANSAXLE _0015110 SPEEDOMETER SENSOR(w/o ABS) G

M5S MANUAL TRANSMISSION / TRANSAXLE  SPEEDOMETER SENSOR(w/o ABS)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 83181A 1.INSPECT SPEEDOMETER SENSOR

E236777C05
2.583,1.281 3.073,1.573 0.49,0.292 1.677,1.542 1.333,2.031 true 2.708,1.344 3,1.5 0.292,0.156 10 E34 0.885,2.063 1.552,2.24 0.667,0.177 10 12 (SPDI) 1.021,4.208 1.24,4.385 0.219,0.177 10 (A) 0.177,0.146 0.365,0.385 0.188,0.24 10 *a 2.927,3.792 3.271,3.948 0.344,0.156 10 GND
*a Component with harness connected
(Combination Meter Assembly)


a.

Start engine and warm it up.


b.

Connect the oscilloscope probes to the SPDI terminal and body ground.


c.

Check the waveform when the vehicle is running at the speed of 20 km/h (12 mph).

Combination meter Terminal Name Between SPDI (E34-12) and Body Ground
Tester Range 5 V/DIV, 20msec./DIV
Condition Vehicle Speed 20 km/h (12 mph)

OK:

The waveform is displayed as shown in the illustration.


HINT:
·

The oscilloscope waveform shown as example does not include noise or chattering waveform.

·

The waveform amplitudes differ slightly depending on the vehicle condition.

·

When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.