42611E
1.REMOVE REAR AXLE HUB BOLT
Mount the rear axle shaft in a soft vise.
Using SST, remove the hub bolt.
89547D
2.REMOVE SKID CONTROL SENSOR ROTOR (w/ ABS)
Grind a part of the skid control sensor rotor with a grinder and split it using a chisel and a hammer to remove it from the rear axle shaft.
Be careful not to damage the rear axle shaft.
42423
3.REMOVE REAR INNER AXLE BEARING RETAINER
Grind a part of the inner retainer with a grinder and split it using a chisel and a hammer to remove it from the rear axle shaft.
Be careful not to damage the rear axle shaft.
42311C
4.REMOVE REAR AXLE SHAFT BEARING
Using SST and a press, remove the bearing.
Be careful not to drop the axle shaft.
Remove the bearing retainer.