Home › Drivetrain › AXLE AND DIFFERENTIAL › DIFFERENTIAL SYSTEM
RM19Y0E _52 Drivetrain _002987 AXLE AND DIFFERENTIAL _0015119 DIFFERENTIAL SYSTEM L

AXLE AND DIFFERENTIAL  DIFFERENTIAL SYSTEM  PRECAUTION  


Before disassembly, clean the outside of the rear differential assembly and remove any sand or mud to prevent it from entering the inside of the assembly during disassembly and reassembly.



When removing a connected part made of light alloy, such as a rear differential carrier cover, tap it off with a plastic hammer. Do not attempt to pry it off with a screwdriver.



Always arrange disassembled parts in order and protect them from dust.



Before reassembly, thoroughly clean and dry each part and then apply hypoid gear oil API GL-5 to them. Do not use alkaline cleaner for aluminum or rubber parts or ring gear set bolts. Also, do not clean rubber parts such as O-rings or oil seals with a non-residue solvent.



Coat any sliding surface or rotating part with hypoid gear oil API GL-5.



When holding a component part in a vise, be sure to place an aluminum sheet between the vise and the part. Do not put it directly in the vise.



Be careful not to damage the contact surfaces of the case. Such damage may cause oil leakage.



Before applying sealant, remove deposited oil sealant and clean the part to be sealed using a non-residue solvent.



Do not add oil immediately after installing sealed parts. Leave it for at least an hour.



Damage on the surface of an oil seal, O-ring or gasket may cause oil leakage.



When pressing in an oil seal, be careful not to damage the oil seal lip or outside periphery.



When replacing a bearing, replace the inner and outer races as a set.