Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER
RM19Y0E _53 Suspension _002989 FRONT SUSPENSION _0015126 FRONT SHOCK ABSORBER A

FRONT SUSPENSION  FRONT SHOCK ABSORBER  REASSEMBLY  


PROCEDURE

Hide 48331 1.INSTALL FRONT NO. 1 SPRING BUMPER

Hide 48132 2.INSTALL FRONT COIL SPRING LH

C144739
0.448,1.458 0.698,1.26 true 0.135,1.396 0.688,1.604 0.552,0.208 10 SST

a.

Using SST, compress the front coil spring LH.

SST
09727-30021  (09727-00010, 09727-00021, 09727-00031)

NOTICE:

Do not use an impact wrench. It will damage SST.



b.
C252095
2.25,1.219 2.156,1.74 true 2.063,1.729 2.573,2.156 0.51,0.427 10 *a
*a Lower End


Install the front coil spring onto the shock absorber.

HINT:

Fit the lower end of the front coil spring into the gap of the front shock absorber.



Hide 48157 3.INSTALL FRONT COIL SPRING UPPER INSULATOR

a.
C272236
1.125,0.969 1.365,0.521 true 1.365,0.365 1.729,0.677 0.365,0.313 10 *a 1.469,1.417 1.833,1.729 0.365,0.313 10 *b 2.594,0.479 2.958,0.792 0.365,0.313 10 A 1.781,0.781 2.146,1.094 0.365,0.313 10 A
*a Arrow mark
*b Knuckle bracket area


Install the front coil spring upper insulator so that the arrow mark on the front coil spring upper insulator is within the knuckle bracket area.


Hide 48044 4.INSTALL FRONT NO. 1 SPRING SEAT SUB-ASSEMBLY

a.
C272237
2.396,0.969 2.573,0.458 true 2.542,0.281 2.917,0.635 0.375,0.354 10 *a 2.698,1.438 3.073,1.792 0.375,0.354 10 *b
*a Arrow mark
*b Knuckle bracket area


Install the front No.1 spring seat sub-assembly so that the arrow mark on the front No.1 spring seat sub-assembly is within the knuckle bracket area.


Hide 5.INSTALL BUSH

Hide 48609A 6.INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY

Hide 7.TEMPORARILY TIGHTEN FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT

a.

Temporarily tighten a new nut.