Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER
RM19Y0E _53 Suspension _002990 REAR SUSPENSION _0015131 REAR SHOCK ABSORBER A

REAR SUSPENSION  REAR SHOCK ABSORBER  INSTALLATION  


PROCEDURE

Hide 48540 1.TEMPORARILY TIGHTEN REAR SHOCK ABSORBER

a.

Support the rear axle housing with a jack.


b.

Temporarily tighten the rear shock absorber (upper side) with the washer and nut.


c.

Temporarily tighten the rear shock absorber (lower side) with the bolt and nut.

NOTICE:

Keep the bolt from rotating and turn the nut.



Hide 2.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 3. STABILIZE SUSPENSION

a.

Lower the vehicle from the jack and bounce it up and down several times to stabilize the suspension.


Hide 48540 4.FULLY TIGHTEN REAR SHOCK ABSORBER

a.

Fully tighten the nut (upper side).

Torque:
66 N*m (676 kgf*cm, 49 ft.*lbf)

NOTICE:

Tighten the nut while the vehicle is empty.



b.

Fully tighten the nut (lower side).

Torque:
89 N*m (908 kgf*cm, 66 ft.*lbf)

NOTICE:
·

Keep the bolt from rotating and turn the nut.

·

Tighten the nut while the vehicle is empty.