Home › Suspension › REAR SUSPENSION › REAR COIL SPRING
RM19Y0E _53 Suspension _002990 REAR SUSPENSION _0015132 REAR COIL SPRING A

REAR SUSPENSION  REAR COIL SPRING  INSTALLATION  


PROCEDURE

Hide 48730 1.TEMPORARILY TIGHTEN REAR LOWER ARM

a.

Temporarily tighten the rear lower arm (front side) with a new bolt and the nut.

NOTICE:

Keep the nut from rotating and turn the bolt.



Hide 48482A 2.INSTALL REAR LOWER SPRING SEAT

a.

Install the rear lower spring seat to the rear lower arm.


Hide 48481 3.INSTALL REAR UPPER SPRING SEAT

a.
C145774
1.885,1.677 2.438,1.49 true 2.438,1.396 2.667,1.583 0.229,0.188 10 *a
*a Paint Mark


Install the rear upper spring seat to the upper side of the rear coil spring.

NOTICE:

Install the rear upper spring seat so that the paint mark on the rear coil spring is at the bottom.



Hide 48231B 4.INSTALL REAR COIL SPRING

a.
C152571
1.521,0.438 2.01,0.115 true 2.083,1.51 2.583,1.698 false 2.031,0.031 2.26,0.24 0.229,0.208 10 *a 2.615,1.677 2.854,1.885 0.24,0.208 10 *b
*a Top End
*b Paint Mark
V100135

Front


Install the rear coil spring to the rear lower spring seat on the rear lower arm.

NOTICE:

Install the rear coil spring so that the paint mark on the rear coil spring is facing down and the rear of the vehicle, or the top end of the coil spring is facing the front of the vehicle.



b.

Support the rear lower arm with a jack. Insert a wooden block between the jack and the rear lower arm to prevent damage.


c.

Slowly jack up the rear lower arm and install the rear upper spring seat to the rear upper spring seat position on the vehicle.


d.

Temporarily tighten the rear lower arm (rear side) with the bolt and a new nut.

NOTICE:

Keep the bolt from rotating and turn the nut.



Hide 46430 5.INSTALL PARKING BRAKE CABLE ASSEMBLY

a.

Install the parking brake cable assembly to the rear lower arm with the bolt.

Torque:
7.4 N*m (75 kgf*cm, 65 in.*lbf)


Hide 6.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 7. STABILIZE SUSPENSION

a.

Lower the vehicle from the jack and bounce it up and down several times to stabilize the suspension.


Hide 48730 8.FULLY TIGHTEN REAR LOWER ARM

a.

Fully tighten the bolt on the rear lower arm (front side).

Torque:
92 N*m (938 kgf*cm, 68 ft.*lbf)

NOTICE:
·

Keep the nut from rotating and turn the bolt.

·

Tighten the bolt while the vehicle is empty.




b.

Fully tighten the nut on the rear lower arm (rear side).

Torque:
97 N*m (987 kgf*cm, 72 ft.*lbf)

NOTICE:
·

Keep the bolt from rotating and turn the nut.

·

Tighten the nut while the vehicle is empty.