Home › Suspension › REAR SUSPENSION › REAR UPPER ARM
RM19Y0E _53 Suspension _002990 REAR SUSPENSION _0015133 REAR UPPER ARM A

REAR SUSPENSION  REAR UPPER ARM  INSTALLATION  


PROCEDURE

Hide 48790 1.TEMPORARILY TIGHTEN REAR UPPER ARM

C144746
1.427,0.24 1.771,0.448 false 2.677,0.635 3.063,0.51 false 0.813,1.865 1.083,2.042 0.271,0.177 10 *d 0.292,0.771 0.51,0.958 0.219,0.188 10 *c 1.229,0.094 1.448,0.281 0.219,0.188 10 *a 3.094,0.406 3.344,0.594 0.25,0.188 10 *b 2.938,1.302 3.177,1.531 0.24,0.229 10 *c
*a RH
*b LH
*c Outside
*d Vehicle Front


a.

Install the upper arm as shown in the illustration.


b.

Temporarily tighten the upper arm (front side) with the nut and a new bolt.

NOTICE:

Keep the nut from rotating and turn the bolt.



c.

Temporarily tighten the upper arm (rear side) with the bolt and a new nut.

NOTICE:

Keep the bolt from rotating and turn the nut.



Hide 89546 2.INSTALL REAR SPEED SENSOR

a.

Connect the 2 clamps to the upper arm.


b.

Install the speed sensor with the bolt.

Torque:
7.4 N*m (76 kgf*cm, 66 in.*lbf)


Hide 3.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 4. STABILIZE SUSPENSION

a.

Lower the vehicle from the jack and bounce it up and down several times to stabilize the suspension.


Hide 48790 5.FULLY TIGHTEN REAR UPPER ARM

a.

Fully tighten the bolt on the upper arm (front side).

Torque:
92 N*m (938 kgf*cm, 68 ft.*lbf)

NOTICE:
·

Keep the nut from rotating and turn the bolt.

·

Tighten the bolt while the vehicle is empty.




b.

Fully tighten the nut on the upper arm (rear side).

Torque:
97 N*m (987 kgf*cm, 72 ft.*lbf)

NOTICE:
·

Keep the bolt from rotating and turn the nut.

·

Tighten the bolt while the vehicle is empty.