Home › Suspension › REAR SUSPENSION › REAR LATERAL CONTROL ROD
RM19Y0E _53 Suspension _002990 REAR SUSPENSION _0015135 REAR LATERAL CONTROL ROD A

REAR SUSPENSION  REAR LATERAL CONTROL ROD  INSTALLATION  


PROCEDURE

Hide 48740 1.TEMPORARILY TIGHTEN REAR LATERAL CONTROL ROD

C133146
1.365,0.646 1.104,0.531 false 1.052,1.521 1.313,1.417 false 2.156,0.729 2.458,0.646 false 2.146,1.323 2.438,1.375 false 2.063,1.031 2.458,1.031 false 1.406,3.354 1.563,3.958 1.563,3.958 2.083,3.521 true 0.927,0.438 1.167,0.625 0.24,0.188 10 *1 0.875,1.469 1.135,1.677 0.26,0.208 10 *1 2.5,0.563 2.74,0.771 0.24,0.208 10 *2 2.5,1.313 2.719,1.469 0.219,0.156 10 *2 2.5,0.938 2.74,1.104 0.24,0.167 10 *3 1.49,3.99 1.677,4.146 0.188,0.156 10 *4
*1 Washer
*2 No. 1 Rear Lateral Control Rod Bush
*3 No. 2 Rear Lateral Control Rod Bush
*4 Mass Damper


a.

Install the lateral control rod, No. 2 rear lateral control rod bush, 2 No. 1 rear lateral control rod bushes and 2 washers onto the rear axle housing, as shown in the illustration.

NOTICE:

Install the lateral control rod with the mass dampers facing downward.



b.

Temporarily tighten a new nut.


c.

Temporarily tighten the lateral control rod (left side) with a new nut, bolt and 2 washers.

NOTICE:

Keep the bolt from rotating and turn the nut.



Hide 2. STABILIZE SUSPENSION

a.

Lower the vehicle from the jack and bounce it up and down several times to stabilize the suspension.


Hide 48740 3.FULLY TIGHTEN REAR LATERAL CONTROL ROD

a.

Fully tighten the nut (left side).

Torque:
87 N*m (885 kgf*cm, 64 ft.*lbf)

NOTICE:
·

Keep the bolt from rotating and turn the nut.

·

Tighten the nut while the vehicle is empty.




b.

Fully tighten the nut (right side).

Torque:
92 N*m (938 kgf*cm, 68 ft.*lbf)

NOTICE:

Tighten the nut while the vehicle is empty.