TROUBLESHOOTING PRECAUTIONS
When there are problems in the terminal contact points or part installation problems, removal and installation of the suspected problem parts may completely or temporarily return the system to normal.
In order to determine the malfunctioning area, be sure to check the conditions at the time the malfunction occurred, such as stored DTCs and the freeze frame data, and record them before disconnecting connectors or removing and installing parts.
Since the system may be influenced by malfunctions in systems other than the anti-lock brake system, be sure to check for DTCs in other systems.
HANDLING PRECAUTIONS
Be sure to remove and install the skid control ECU (brake actuator assembly) and each sensor, etc. with the ignition switch off unless otherwise specified in the inspection procedure.
If the skid control ECU (brake actuator assembly) or a sensor has been removed and installed, it is necessary to check the system for problems after the parts have been reassembled. Check for DTCs using the intelligent tester, and also check that system functions and signals received by the ECU are normal using Test Mode.
DTC PRECAUTION
Warnings for some DTCs cannot be cleared only by repairing the malfunctioning parts. If a warning is displayed after repair work, the DTC should be cleared after turning the ignition switch off.
If a part is still malfunctioning even after the DTC is cleared, the DTC will be stored again.