Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2011.11–2015.08
RM19Y0E _54 Brake _002992 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0015137 ANTI-LOCK BRAKE SYSTEM U

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  TERMINALS OF ECU  


TERMINALS OF ECU


C248685C02
0.161,0.094 0.348,0.255 0.186,0.161 10 *a
*a Component without harness connected
(Skid Control ECU (brake actuator assembly))


Terminal No. (Symbol) Terminal Description
1(GND1) Skid control ECU ground
4 (RL-) Rear wheel speed LH (-) signal input
5 (RL+) Rear wheel speed LH (+) signal input
6 (FR-) Front wheel speed RH (-) signal input
7 (FR+) Front wheel speed RH (+) signal input
12 (+BS) Solenoid relay power supply
13 (GND2) Pump motor ground
16 (RR-) Rear wheel speed RH (-) signal input
17 (RR+) Rear wheel speed RH (+) signal input
18 (FL-) Front wheel speed LH (-) signal input
19 (FL+) Front wheel speed LH (+) signal input
20 (SIO) Sensor diagnosis check input
21 (WA) ABS warning light output
22 (VOUT) Speed signal output for speedometer
23 (BRL) Brake warning light output
24 (+BM) Motor relay power supply
28 (STP) Stop light switch input
30 (PKB) Parking brake switch input
32 (ECUT) ABS warning light output
34 (+IG) Front wheel speed RH (-) signal input


TERMINAL INSPECTION


a.
C248686C10
1.458,0.542 1.948,0.833 0.49,0.292 0.156,0.26 0.552,0.594 0.396,0.333 10 *a 1.573,0.615 2.083,0.875 0.51,0.26 10 B10
*a Component without harness connected
(Skid Control ECU (brake actuator assembly))


Disconnect the connector and measure the voltage or resistance on the wire harness side.

HINT:

The voltage cannot be measured with the connector connected to the skid control ECU (brake actuator assembly) as the connector is watertight.


Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
B10-1 (GND1) - Body ground W-B - Body ground Skid control ECU ground Always Below 1 Ω
B10-12 (+BS) - Body ground P - Body ground Solenoid relay power supply Always 11 to 14 V
B10-13 (GND2) - Body ground W-B - Body ground Pump motor ground Always Below 1 Ω
B10-21 (WA) - Body ground V-R - Body ground ABS warning light output Ignition switch ON, ABS warning light on Below 1 V
B10-24 (+BM) - Body ground W-R - Body ground Motor relay power supply Always 11 to 14 V
B10-28 (STP) - Body ground G-Y - Body ground Stop light switch input Brake pedal depressed → released 6 to 14 V → Below 2 V
B10-30 (PKB) - Body ground LG-R - Body ground Brake warning line Ignition switch ON, brake warning light on Below 1 V
B10-34 (+IG) - Body ground W-G - Body ground ECU power supply Ignition switch ON 11 to 14 V