Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR › 2011.11–2015.08
RM19Y0E _54 Brake _002992 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0015138 BRAKE ACTUATOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR  REMOVAL  


PROCEDURE

Hide 1.DRAIN BRAKE FLUID

NOTICE:

Immediately wash off any brake fluid that comes into contact with any painted surface.


Hide 44510 2.REMOVE BRAKE ACTUATOR ASSEMBLY

a.
C248972

Disconnect the wire harness clamp from the brake actuator bracket assembly.


b.

Pull the lock lever upward and disconnect the connector.

NOTICE:

Be careful not to allow brake fluid to enter the removed connector.



c.
C248973

Using a 10 mm union nut wrench, disconnect the 6 brake lines from the brake actuator assembly.


d.
C248974
0.844,0.74 0.844,0.646 false 1.281,0.854 1.281,0.74 false 1.781,1 1.781,0.854 false 2.115,1.031 2.115,0.823 2.115,0.823 2.167,0.823 true 0.844,1.375 0.729,1.375 0.729,1.375 0.573,1.177 true 1.573,1.656 1.656,1.656 1.656,1.656 1.854,1.5 true 0.76,0.76 1.146,1.177 0.385,0.417 10 *a 0.865,1.302 1.208,1.625 0.344,0.323 10 *e 1.385,1.583 1.771,1.958 0.385,0.375 10 *f 1.198,0.875 1.594,1.292 0.396,0.417 10 *b 1.698,1.021 2.021,1.344 0.323,0.323 10 *c 2.042,1.083 2.479,1.563 0.438,0.479 10 *d
*a to front wheel LH
*b to rear wheel RH
*c to rear wheel LH
*d to front wheel RH
*e from master cylinder FL-RR
*f from master cylinder FR-RL


Place tags or marks to identify the installation locations of each brake line.


e.
C248975

Remove the 3 bolts and the brake actuator assembly with brake actuator bracket assembly.


Hide 44590 3.REMOVE BRAKE ACTUATOR BRACKET ASSEMBLY

a.

Using a 6 mm hexagon wrench, remove the 3 hexagon bolts and the brake actuator bracket assembly.


Hide 44547B 4.REMOVE BRAKE ACTUATOR BRACKET CUSHION

a.

Remove the 3 brake actuator bracket cushions.